ClickCease

SUMP PUMP INSTALLATION & REPAIR SERVICES IN BUCKS COUNTY

Sump Pump Installation Company

A sump pump is a crucial piece of equipment for any homeowner with a basement. It helps to prevent flooding by pumping water out of the basement and away from the foundation of the house. If you’re in need of a sump pump, it’s important to have it installed by a professional to ensure it’s done correctly and will operate effectively.

Before installing a sump pump, a professional will assess your basement to determine the best location for the sump pit. This is the area where the pump will be placed and where water will collect before being pumped out. The location of the sump pit is important, as it should be easily accessible for maintenance and repair, and it should be located in an area that is prone to water accumulation.

Contact our basement waterproofing company today to get started today.

Get Your Estimate Started Today

Ranked #1 in PA Since 2017

Did you Know?

60% of Homes in the U.S. Have Some Form of Water Penetration in The Basement.

Sump Pump Installation & Repair Steps

The first step in installing a sump pump is to identify the location where the pump will be installed. The best location is typically at the lowest point in the basement or crawl space, where water is most likely to collect. The area should be free of debris and large enough to accommodate the pump and any additional equipment that may be required.

Once the location has been identified, the next step is to dig a hole for the sump pump. The hole should be deep enough to allow the pump to sit at least six inches below the floor, to ensure that it can effectively remove water from the area. The hole should also be wide enough to accommodate the pump and any additional equipment, such as a check valve or a discharge hose.

After the hole has been dug, the next step is to prepare the area for the sump pump. This typically involves installing a sump pit, which is a container that will hold the pump and any excess water. The sump pit should be lined with a plastic liner to prevent water from seeping into the surrounding soil and to make it easier to clean.

Once the sump pump is connected to a power source, the next step is to connect it to the plumbing system. This is typically done using PVC piping, which is durable and resistant to corrosion. The piping should be installed in such a way that it allows water to flow easily from the sump pit to the sump pump, and from the sump pump to the point where it is discharged from the property.

Accreditations

Written Estimates For Homeowners and Commercial Businesses are Completed Upon Visual Inspection Of Your Job